Sewage ejector pumps work to expel sewage from a home. They are usually powered by a submersible motor. But they are not foolproof. Some types of sewage pumps are equipped with alarms to alert the homeowner when a pump malfunctions. To keep them functioning properly, homeowners should make sure they follow all the instructions carefully. Aside from following the manufacturer’s instructions, they should also check their water level alarms.
Water level alarm
Sewer ejector pumps are designed to run for approximately seven to 10 years. However, some models may last even longer. In addition, many of these pumps have a built-in water level alarm that activates when the fluid level rises. If the pump fails to activate, it can damage itself, causing a costly malfunction. The alarm can be disengaged for easy installation, however, and you can then safely use the pump without worrying about flooding.
If you notice that your pump is indicating a high water level, you can turn it off by pressing a red “off” button on the pump itself. If the pump is not functioning, the warning light may stay lit until the problem is resolved. It is never a good idea to attempt to troubleshoot an alarm if you do not have enough knowledge about it. If you do, you may fall into the septic pit or suffer an electric shock.
An alarm works in concert with your septic system. When the water level in the pump tank is too high, the alarm will sound to alert you to check your septic system. A pump timer is often installed in all septic systems that use pumps. The timer regulates the pump intervals so that they occur at crucial times of the day. An overflow can harm your drain field.
Rotating blades
Rotating blades in sewer ejector pumps are used to suck solid materials from pipes. They are designed to enter the pipe along its axis and radius and run out through the pump’s blades. The rotating blades in the ejector pump also reverse the direction of every pump cycle, ensuring that solids are separated from the liquid. They are also highly efficient, and able to remove up to 50,000 liters per hour of wastewater and other liquid waste from a building.
Sewage ejector pumps are submersible utility pumps designed for processing solids. They are typically used to pump raw sewage that contains substantial amounts of solids. Some ejector pumps do not contain grinder blades, but they do have rotating blades to crush solids into small particles. As the solids pass through, they are ejected through the outlet.
The rotating blades in a sewer ejector pump are designed to sever solids before they are discharged. Typically, a solids handling pump is more appropriate for this type of wastewater, since it is much thicker. A grinder pump, on the other hand, features rotating blades that grind solids before discharging. Despite their name, they may be used to remove solid waste from any pipe, including deep burying.
Submersible utility pump
A submersible utility or sewage ejector pump is used to remove water from a sewage line. A submersible utility pump is installed at the lowest point of a building’s foundation. The pump channels groundwater into a perimeter drainage system. These drains have perforated pipes to allow water to escape, and discharge to the nearest storm drain, retention pond, or dry well.
A sewage ejector pump is a type of submersible utility or sewage pump that is designed to handle a large volume of solid waste. These pumps can pump sewage up to two inches in diameter, and range in power from three-tenths of horsepower to two horsepower. They are typically used for short distances under seven hundred feet and are available in standalone and preassembled systems. Typically, a pre-assembled system is easier to install and lasts longer. Sewage ejector pumps are also more affordable than grinder pumps.
A utility pump comes in many shapes and sizes. These pumps are typically designed to move water temporarily and are often used in sinks, water heaters, and other areas. They can also be used to drain water from a water heater. Most utility pumps do not have a float switch, so they require manual operation to avoid damaging the motor. If a power outage occurs, hand-operated pumps are an excellent backup. Smaller, 12volt models are great for RVs and boats.