Preparation is the key to kitchen renovations in Brisbane. Any renovation job requires individuals to start out by preparing the area and obtaining the proper supplies to complete a task.

An individual can visit shops to find tile samples to compare in their home. After choosing the tiles, the next step will be to decide how many tiles will be needed. The area should be measured to discover the amount of tiles that would be required. In addition, the size of the tiles will be a factor in the number of tiles needed for the space. Tilers in Brisbane can recommend the proper amount of tiles needed if individuals have taken the time to get the proper measurements.

Preparing the Area

If the kitchen has old tiles installed, they will need to be removed before beginning work on the new tiles. Using a chisel and a hammer, break and pull up the old tiles. The room will be covered in the dust from the plaster, which means the next step will be to clean up the room. Next, check the walls to make sure that they are smooth and flat. New tile will be easier to install on a flat surface. A finishing plaster can be applied on the wall to make it smooth.

Installing the Tiles

Before starting the tiling, use tile adhesive to install the edging trim. Then, install the tiles by applying tile adhesive to the backs of each tile with a spatula. Plastic tile spacers will be used to help ensure the tiles are spaced correctly, and a spirit level can be used throughout the process to make sure that the tiles are being placed level.

How to Tile a Kitchen

Installing Tile in Delicate Areas

Some areas in the kitchen will require a little more attention to detail. For instance, the tiles that connect to the counters will need a different technique. After installing the tiles above the counters, allow the tile adhesive to set before applying a silicon sealant to seal the tiles. This sealant will help keep the water out. Dry grout will need to be applied to the sealant with a brush and left to dry before finishing the project.

Other delicate areas are around the windows and electrical sockets. The windows and sockets require using an electric tile cutter to make special cuts in the tiles, and the tiles will fit better around the sockets if the sockets are removed from the wall before cutting the tiles. Allow the tile adhesive to dry completely before reinstalling the sockets. If the tiles are not as accurate as someone would like, the flaws can be covered up later with grout.

The Fun Part of Tiling the Kitchen

After the tile adhesive is dried, the grouting can begin. Grout will need to be mixed up to a certain consistency. The grout will need to be thick enough to stay on a stick when removed from the bucket, and then, applied with a spatula. Apply the grout to the wall making sure some of the grout goes in the joints between each tile. After covering the wall with the grout, use a damp sponge to remove any unnecessary grout from the tiles before the grout dries. Make sure that the grout has covered all the areas that needed grout, and then, let it dry.

Finishing the Job

Clean up the work area of any dust from the tiling, and start enjoying the new tiled kitchen. If you need more information about kitchen tiling click here.

Leave a Reply

Your email address will not be published. Required fields are marked *